Practical and Helpful Tips: Cutting

Stainless Steel and Aluminum Can Benefit from Waterjet Cutting

Waterjet cutting was first introduced in the 1950s. From that time on, it has undergone tremendous improvements and proven as a very effective way to cut almost all flat materials, including aluminum and stainless steel.

The waterjet cutter utilizes a stream of water at high pressure to slice through or cleanse materials. This cutter is usually attached to some high-pressure water pump that ejects the water from its nozzle, and then slices through the object using high-pressure water. Additives, typically as abrasives, are added to assist with the procedure.

The following are a few benefits of utilizing a waterjet cutter for aluminum sheet and stainless stee;

The Strengths of Waterjets
Although at first, you perhaps did not imagine as such a potent cutting tool, waterjet cutters are equipped with the ability for cutting through in so far as 8-inchess of stainless steel and 10-inches of aluminum.
Absence of Heat

The water jet cutting method is the preferred method when cutting materials that are vulnerable to heat which is often generated with the use of other methods. Because ot does not have heat-affected-zone, HAZ, there is lesser danger of destroying the surface of the object being cut.

Utmost Precision
Waterjet cutters are extremely precise because they can attain a 0.005″ accuracy or 0.13 mm, and 0.001″ or 0.03 mm repeatability. Using the waterjet technique to cut through steel or aluminum is not just precise, but it likewise produces a spike-free finish. This does away with the need to carry out a consequential surface finishing most of the time, which can save you some amount of money.

Speed
Cutting projects with the use of a waterjet is extremely quick and efficient. There are quite a few explanations for this:

1. It takes lesser time to set it up.

2.The cutting process is more immediate over other methods.

3. Re-cutting becomes unnecessary because of the waterjet’s accuracy.

Ecologically Sensible
Waterjets make use of green technology One reason is the absence of hazardous waste generated during the cutting process. Next, as large pieces of scrap material which are reusable can be sliced off, the water jet eliminates unnecessary wastes that are often a result when utilizing traditional cutting procedures.

Using the waterjet cutter for steel and aluminum is even more beneficial. A waterjet uses a very small amount of water. It actually consumes about one half gallon to a gallon of water per minute. The amount is dependent of the orifice size of its cutting head.

Additionally, water that has been used is reusable by means of close-looped systems. Waste water happens to be clean enough most of the time to filter as well discard via a drain.

Safer Work Surroundings
Waterjet cutters eliminate airborne dust elements. smoke, fumes, and other contaminants as a result of cutting materials. There is a great improvement in the work surroundings as it cuts down the problems resulting from a machine operator’s contact.

What Research About Equipment Can Teach You

Questions About Equipment You Must Know the Answers To